MakerWorld
Gadgets
Go to Model
Switch Lite Pro Controller Mount
102
Downloads
43
Likes
47
Makes
SummaryVery simple print to securely hold your switch above your controller. Brings it closer to you while allowing use of the pro controller, and is nicely balanced. Carefully open up after printing in case any filament fused at the closure, and then snap around controller at the front.Print SettingsNotes: Print without support. 3-4 shells and ~20% infill. PETg works great for the flex but other materials should be fine
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
