Thingiverse
Sword
door VirtualPenguin
0
Downloads
3
Likes
0
Makes
This sword was made so the inside is hollow this will allow a light to be put inside to make it glow. The sword prints in separate sections and assembly is needed. The pins to hold the blade in the handle are made so the blade can be removed.
Blad prints in 4 pieces - with the middle section of the blade allowing being able to connect to each other to make a longer sword
Hande prints in 2
https://youtu.be/wwIK7DSF7Eg
Blad prints in 4 pieces - with the middle section of the blade allowing being able to connect to each other to make a longer sword
Hande prints in 2
https://youtu.be/wwIK7DSF7Eg
VirtualPenguin publiceert ook op
6 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
