Synthstrom Deluge side cheeks (Including optional embedded J-Link EDU Mini Debug Probe)

Printed on a Bambu X1C in PETG with a 0.4 nozzle, 0.2 layer height, 15% gyroid infill, no supports. Included STEP files:Left cheekTwo versions of the right cheek:With a cutout for the J-Link EDU Mini debug probe (for debugging Deluge Community Firmware)Without any kind of cutoutRight cheek debug probe assembly instructions (also see the photos):Press the debug probe in place. It should be a tight fit, but not too tight to remove if needed.Attach the included SWD cable, by aligning the red wire to pin 1 on the debug probe and the arrow on the Deluge PCB.Slide the cover in place. It should be a snug fit.General assembly instructions:Don't over-tighten the screws!Notes:The Deluge doesn't actually come with a SWD header installed on the PCB. You'll need to install one yourself, which will almost certainly void your warranty. See the Adding a Debug Header to your Deluge section of the Deluge Community Firmware docs for instructions.The white “THE ENTIRE ROBOT” text and stripe in the photos