Table stand/support for wall clock

#Table stand/support for wall clock
This is a stand/support for a wall clock (diameter ~30cm). To put a wall-clock on a table instead of a wall installation.

##Design

Done with Freecad. Please support them.

-----------------------------------
##Print
Realized with a Prusa Mini.
- PLA
- 0,25mm Draft mode
- infill 15%

**Note** : due to the height, necessary to use the cutting feature from Prusa Slicer to print the support in two-part.
Both parts have finally been glued together.
It is suitable since the stand is finally masked by the clock.