Thingiverse
Table Wall Mount
door Hella3D
0
Downloads
0
Likes
0
Makes
1" table wall mount. Keeps a snug fit against the wall. Other parts (handle and leg holders) in the picture are from other creators I got from Makerworld.
handles by Meesy and Broom/Mop Holder (scaled up for table legs) by Eneo3d
The longer side is on the top for the table to slide into. I kept the tolerances real close for a snug fit. Once the table is slid into the upper mount you just push your bottom part of the table to wall and ease it into the bottom mount.
I attached a .obj, hopefully that will work for you to adjust for whatever size and thickness board you are using.
handles by Meesy and Broom/Mop Holder (scaled up for table legs) by Eneo3d
The longer side is on the top for the table to slide into. I kept the tolerances real close for a snug fit. Once the table is slid into the upper mount you just push your bottom part of the table to wall and ease it into the bottom mount.
I attached a .obj, hopefully that will work for you to adjust for whatever size and thickness board you are using.
Hella3D publiceert ook op
7 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
