Thingiverse
Tabletop Hexes
von Danielboyz
11
Downloads
2
Likes
0
Makes
Some board game bits/cards coasters.
2 cm high, sides 6 cm each, total width about 12cm.
Magnet holes are for 6x2mm magnets. You should be placing them in alternating directions (north/south)
Couple of varieties with different numbers of holes or card holders.
I have also made some hex holders that can be used for easy/clean storage.
I would be happy to fulfill requests for different sizes, maybe another type of hex, magnets etc.
2 cm high, sides 6 cm each, total width about 12cm.
Magnet holes are for 6x2mm magnets. You should be placing them in alternating directions (north/south)
Couple of varieties with different numbers of holes or card holders.
I have also made some hex holders that can be used for easy/clean storage.
I would be happy to fulfill requests for different sizes, maybe another type of hex, magnets etc.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
