Thingiverse
Tachometer Case
von highdeserthacker
3
Downloads
0
Likes
0
Makes
A mount for an LED display for the common low cost electronic tachometers found online.
Mine uses the DIGITEN brand, found at https://www.amazon.com/dp/B07X4F8QVP, ASIN: B07X4F8QVP.
Using this on my mill spindle.
LED assembly snaps in. Any of the clones with insert dimensions of appx 2 3/4" x 1 3/8" should fit. Note that the back is open.
I drill holes for mounting a dc adapter plug. If your enclosure is close enough, can mount the hall effect sensor in this too.
Mine uses the DIGITEN brand, found at https://www.amazon.com/dp/B07X4F8QVP, ASIN: B07X4F8QVP.
Using this on my mill spindle.
LED assembly snaps in. Any of the clones with insert dimensions of appx 2 3/4" x 1 3/8" should fit. Note that the back is open.
I drill holes for mounting a dc adapter plug. If your enclosure is close enough, can mount the hall effect sensor in this too.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!