Thingiverse
Tacoma 3rd Gen Button Insert - Momentary button insert
by EasyT2022
12
Downloads
6
Likes
0
Makes
Here is a button insert for the 3rd Gen Toyota Tacoma. I created it to use with a garage door opener.
Files included:
1. Button casing
2. Momentary button insert (for use with 6mm 4 pin momentary button)
3. Button
I printed the button casing flat on its face with supports for the tabs on either side. I also printed the button upright with supports however given the tight tolerances I feel it could simply be printed flat without an issue. (removing the small x piece sticking out of the back)
Files included:
1. Button casing
2. Momentary button insert (for use with 6mm 4 pin momentary button)
3. Button
I printed the button casing flat on its face with supports for the tabs on either side. I also printed the button upright with supports however given the tight tolerances I feel it could simply be printed flat without an issue. (removing the small x piece sticking out of the back)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
