Slicer Discord
Teal Timer Holder – 3D-Druckmodell von Thingiverse Thingiverse

Teal Timer Holder

von TuckyIA
0 Downloads
1 Likes
0 Makes
Zum Modell
Here is an attachment that seems obsolete at first, but some imagination gives great results.
Picture this: You are flying your drone. It suddenly runs out of battery over a piece of forest. It drops to the ground and you go to try and find it. Normally, this would take a long time to find, but with the timer installed, it will beep after a certain amount of time. A beeping drone is a whole lot easier to find than a silent one. Please note I have not tested this yet. Also, this can alert you if the battery time is running low by setting it to however long your battery lasts on average for your runs, then subtracting one minute. This is especially useful when you lose track of time or never look at any battery indicator. A drone found on the ground in the middle of nowhere can be repaired, while a lost drone can not. You would have to buy a new drone. That is why you would want this.

Designed for: https://www.amazon.com/Digital-Kitchen-Magnetic-Adjustable-Retractable/dp/B0745WH7C2/r
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen