Tech Deck replacement connectors

This Tech Deck Starter Kit was missing a few pieces. So, I designed and printed replacement connectors.Note: you must use the 3MF or it will be too tight. I used -0.1 mm contour compensation, so use this if you download the STL. This can be adjusted if your printer or filament is slightly different but should be generally fine. I printed with Bambu Basic Blue-Gray PLA.Plate 1: 40mmPlate 2: 10mmI only had one piece which was 40mm, and I assume that the smaller size was 10mm based on the set. The set normally comes with 4 long/40mm pieces, and 2 short/10mm pieces.Plate 3: Set 1What the set normally comes with + 2 short piecesPlate 4: 6 of each6x 40mm, + 6x 20mm, + 6x 10mm.Plate 5:Medium version that does not come with the set at all.If you would like to scale it to any height, you can in Bambu Studio.