Thingiverse
Music
Vai al Modello
Telecaster Switch Cap
19
Download
18
Likes
0
Makes
Selector Switch Cap for a telecaster.
Make sure you dont print too hot or the tolerances will be too tight on the knob. Should be a little bit of an effort to get on. Use a small screwdriver or sweezers to widen the edge of the hole out a bit if its too difficult to press on.
Make sure you dont print too hot or the tolerances will be too tight on the knob. Should be a little bit of an effort to get on. Use a small screwdriver or sweezers to widen the edge of the hole out a bit if its too difficult to press on.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
