Thingiverse
Temperature Controller Enclosure
par jdurand
49
Téléchargements
39
Likes
1
Makes
This enclosure is to hold a standard low cost temperature controller. Probe holder over here: http://www.thingiverse.com/thing:117711
I had some trouble printing it when the room temperature suddenly changed, but the box came out usable. I did have to scrape the opening for the controller as part of the controller was a little wider than where I had measured.
It's a retrofit so it mounts with one screw (with washer) through the bottom of the case and the sensor, fan, and heater wires go through the tapered hole.
The elongated hole in the rear is for a power cord strain relief, the type you squeeze onto the cord and press in. There's a resess because the strain relief won't clip on thick material.
The lid with some conversions on it is leaning against the side.
The upper holes are for cooling.
A #4 nut slides into the pockets in the side tabs so you can screw the lid on.
I made the name plate on a CNC mill.
I had some trouble printing it when the room temperature suddenly changed, but the box came out usable. I did have to scrape the opening for the controller as part of the controller was a little wider than where I had measured.
It's a retrofit so it mounts with one screw (with washer) through the bottom of the case and the sensor, fan, and heater wires go through the tapered hole.
The elongated hole in the rear is for a power cord strain relief, the type you squeeze onto the cord and press in. There's a resess because the strain relief won't clip on thick material.
The lid with some conversions on it is leaning against the side.
The upper holes are for cooling.
A #4 nut slides into the pockets in the side tabs so you can screw the lid on.
I made the name plate on a CNC mill.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
