Thingiverse
Temperature Tower
von Nowerr
112
Downloads
64
Likes
0
Makes
A remake of stoempie's Temp Tower
https://www.thingiverse.com/thing:2493504
I just wanted a longer bridge section to really test my prints, and I changed the temperatures to rather average temperatures to the PLA's I have laying around. I'm not sure yet but I might make 2.5-degree intervals to dial in specific filaments.
This can be completed in Cura by going to Extensions-Post Processing-Modify G-Code-Add a script-TweakAtZ
From there you can change the temperature at layers in increments of 75 to correspond with the written temperatures.
https://www.thingiverse.com/thing:2493504
I just wanted a longer bridge section to really test my prints, and I changed the temperatures to rather average temperatures to the PLA's I have laying around. I'm not sure yet but I might make 2.5-degree intervals to dial in specific filaments.
This can be completed in Cura by going to Extensions-Post Processing-Modify G-Code-Add a script-TweakAtZ
From there you can change the temperature at layers in increments of 75 to correspond with the written temperatures.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
