Tensegrity table structure

Tensegrity table,

I saw this thing in a youtube video and was made out of aluminium. Looked cool and decided to make it myself. So drew the structure and printed it.

The top disc is the one with the little plugs in the fishing line holes on the edge. The bottom disc has the bigger dome shaped holes hidden on the underside were it is unseen.

The standing posts are press fitted in the discs. In case the result is not tight enough on your print just add some glue. Use a 1 mm drill to make the 3 holes in the center of the 3 dome holes on the edge on the underside of the bottom disc. also check if the holes in the 3 little plugs are open. if not drill them too. And drill the last hole on the thin end in both standing posts to make sure it is open

To assemble the structure with the fishing line I started to add the three disc-edge wires. I used thin metal wire as a retainer on the other side of the plug in the hole since just a nut in the fishing line was not big enough. Put the