Thingiverse
terminal connector block
von krikey
16
Downloads
4
Likes
0
Makes
After adding the DeWalt D26200 to my X-Carve, I needed to extend the mains supply using a new piece of flex. I made this model to suit my purposes.
The box walls are 3mm thick and act like clamps on the flex cable. There are two central pins that hold a 3 terminal block in place.
If you liked my design and want to show your appreciation,why not leave a small donation of a £/$/€ or two through the blue TIP BUTTON on the left.
The box walls are 3mm thick and act like clamps on the flex cable. There are two central pins that hold a 3 terminal block in place.
If you liked my design and want to show your appreciation,why not leave a small donation of a £/$/€ or two through the blue TIP BUTTON on the left.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
