Test flow cube
door stenc55
30
Downloads
20
Likes
0
Makes
Cube 20x20x20mm
Walls 0.8mm
Test y,x,z dimensions. If they are wrong (exactly 20mm), you can do a axis steps calibration as you did e steps.
Wall should be exactly 0.8mm. Adjust flow rate in slicer accordingly.
Walls 0.8mm
Test y,x,z dimensions. If they are wrong (exactly 20mm), you can do a axis steps calibration as you did e steps.
Wall should be exactly 0.8mm. Adjust flow rate in slicer accordingly.
stenc55 publiceert ook op
25 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
