Test_support
von NewMoi
17
Downloads
10
Likes
0
Makes
Small test piece to test support settings.
The part is a little bit bigger than the original desgin 40 x 40 x 15 and printed in around 2 hours at 0.16 mm layer height.
;==========================================================================
; Documentation
;==========================================================================
; Profile ( Version Cura 4.3.0 ) : A13 (0.16)
; Quality : Super Quality
; Material : PLA
; Diameter : 1.75 mm
; Nozzle Diameter : 0.4 mm
;-------------------------------- Quality --------------------------------
; Layer Height : 0.16 mm
; Initial Layer Height : 0.2 mm
; Line Width : 0.4 mm
; Initial Layer Line Width
The part is a little bit bigger than the original desgin 40 x 40 x 15 and printed in around 2 hours at 0.16 mm layer height.
;==========================================================================
; Documentation
;==========================================================================
; Profile ( Version Cura 4.3.0 ) : A13 (0.16)
; Quality : Super Quality
; Material : PLA
; Diameter : 1.75 mm
; Nozzle Diameter : 0.4 mm
;-------------------------------- Quality --------------------------------
; Layer Height : 0.16 mm
; Initial Layer Height : 0.2 mm
; Line Width : 0.4 mm
; Initial Layer Line Width
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
