TEVO Cable Guide

This cable guide keeps the "high" cables off of the low cables to prevent them from catching on each other.

I designed this specifically for the way my TEVO sits on my desk. I put the control box behind and to the left of the printer so I have easy access to it (see pictures).

It comes in three parts to make printing easier, and nothing needs a raft or supports.

I used M3 x 20mm screws on the side with the guide post, and M3 x 10mm screws on the other. There are small indentions in the under side of the leafs of the base to hold the nuts.

The base is designed so it aligns with the back of the control unit, and the feet of the control unit go through the large holes. The small round indention next to the large holes accommodate the screws holding the cabinet together.