Slicer Discord
the back Scratcher – 3D printable model from MakerWorld MakerWorld
Hand Tools

the back Scratcher

457 Downloads
669 Likes
222 Makes
Go to Model
✅ New version updates:No more supports for spikes requiredSpikes print cleanly - just give them a light sanding only if they feel too sharp for your skinEasier, lighter print with the same satisfying results You know that annoying itch right in the middle of your back? The one you can almost reach? This little tool takes care of it, no awkward stretching, no asking someone else. Just place it on a thin, rolled towel, and move it over your back like you’re drying off after a shower. The spikes do the work. Simple, satisfying, and honestly kind of addictive. It reaches everywhere and hits just right, not too sharp, not too soft. Way better than those stick scratchers that miss the spot or leave you wanting more. ⚠️ Warnings & Tips:If you have birthmarks, moles, or sensitive spots on your skin, don’t use the scratcher on bare skin.Start slow. Use gentle pressure at first and adjust the angle or leverage as you get the feel for it. You’ll quickly find your sweet spot.Sand the spikes lightl
Category
Hand Tools
Source
MakerWorld
Published
Updated
What you need to print this: Intermediate Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
PLA
Post-processing
Sanding
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection