Slicer Discord
the back Scratcher – 3D-Druckmodell von MakerWorld MakerWorld
Hand Tools

the back Scratcher

457 Downloads
669 Likes
222 Makes
Zum Modell
✅ New version updates:No more supports for spikes requiredSpikes print cleanly - just give them a light sanding only if they feel too sharp for your skinEasier, lighter print with the same satisfying results You know that annoying itch right in the middle of your back? The one you can almost reach? This little tool takes care of it, no awkward stretching, no asking someone else. Just place it on a thin, rolled towel, and move it over your back like you’re drying off after a shower. The spikes do the work. Simple, satisfying, and honestly kind of addictive. It reaches everywhere and hits just right, not too sharp, not too soft. Way better than those stick scratchers that miss the spot or leave you wanting more. ⚠️ Warnings & Tips:If you have birthmarks, moles, or sensitive spots on your skin, don’t use the scratcher on bare skin.Start slow. Use gentle pressure at first and adjust the angle or leverage as you get the feel for it. You’ll quickly find your sweet spot.Sand the spikes lightl
Kategorie
Hand Tools
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Schleifen
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen