The BlockBox - BitAxe Case

I present The BlockBox — This is my first 3D model. I designed this primarily for an aesthetic way to display my BitAxes on my office shelf. (Please note: I have not tested the cooling aspect of this case. The 120mm fans should provide sufficient cooling to run miners at default settings but my plan was never to overlock within this case.) Highlights— Two 120mm fans pulling air from the bottom and exhausting through the top— Fan controller located on the front of the case for easy adjustments— Single board mount for Two BitAxe 601&#39;s. Slotted into the case for easy install and removal— Space for PSU bricks in the case Additional Components Needed8x2mm Round Magnets — 24x – amazon120mm Fans — 2x – amazon18&#34; PWM Extension Cable — 1x – amazonPWM Fan Controller — 1x – amazon90° Elbow Charging Connectors — 2x – amazonAcrylic Sheet — 1x - <a target="_blank" rel="noopener noreferrer ugc" href="https://www.amazon.com/2-Pack-Clear-Acrylic-Sheet-Plexiglass/dp/B09WHWXNZD/ref=sr_1_6_sspa?cr