Thingiverse
The Doorman - Eyelids
von Extraball
9
Downloads
10
Likes
0
Makes
Better printable eyelids. You dont need to print em with support but at least you need a coolerfan. The one in the picture was printed without support.
The holes in the bar are not for the motor-rods. Bend the rods arround the bar and if it moves sideways during the motor motion use the holes to block it.
Tips:
Use a _arduino nano_ instead of an arduino (its cheaper and smaller). An additional shield makes this much easier to wire (and reusable) for only ~ 2,- more bucks.
---
This whole project is a mess. Nothing fits together and no wiring documentation (whats with the 3300 µf capacitor and the batterypack?!?). You need much hot glue. If you really want to build this, use optimised parts.
The holes in the bar are not for the motor-rods. Bend the rods arround the bar and if it moves sideways during the motor motion use the holes to block it.
Tips:
Use a _arduino nano_ instead of an arduino (its cheaper and smaller). An additional shield makes this much easier to wire (and reusable) for only ~ 2,- more bucks.
---
This whole project is a mess. Nothing fits together and no wiring documentation (whats with the 3300 µf capacitor and the batterypack?!?). You need much hot glue. If you really want to build this, use optimised parts.
Extraball veröffentlicht auch auf
31 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
