Thingiverse
The Luftwaffle
door Luftwaffles47
0
Downloads
0
Likes
0
Makes
Look out! It's the Luftwaffle!
My username is a pun about waffles and the German air force (Luftwaffe), figured I should bring that to life!
This is a model of the German BF109 fighter, with a silly waffle texture added.
The seams of the assembly are aligned with the waffle texture, so with a clean print they should be very well hidden.
You will most likely need supports for the tail unless you use a very small layer height.
Holes are present in each fuselage piece to use 1.75mm filament to join the pieces together, but I recommend using glue as well. The propellor clips into place (depending on the quality of the print the clip may need to be sanded a little). I attached the wheels using M3 bolts, but you could probably just glue them in place, they don't really roll much.
Note, this plane does not actually fly :p
I hope you enjoy this silly little joke :)
My username is a pun about waffles and the German air force (Luftwaffe), figured I should bring that to life!
This is a model of the German BF109 fighter, with a silly waffle texture added.
The seams of the assembly are aligned with the waffle texture, so with a clean print they should be very well hidden.
You will most likely need supports for the tail unless you use a very small layer height.
Holes are present in each fuselage piece to use 1.75mm filament to join the pieces together, but I recommend using glue as well. The propellor clips into place (depending on the quality of the print the clip may need to be sanded a little). I attached the wheels using M3 bolts, but you could probably just glue them in place, they don't really roll much.
Note, this plane does not actually fly :p
I hope you enjoy this silly little joke :)
Luftwaffles47 publiceert ook op
31 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
