Slicer Discord
The Pringle Sleeve – 3D-Druckmodell von Thingiverse Thingiverse

The Pringle Sleeve

120 Downloads
187 Likes
1 Makes
Zum Modell
Since grade 9 I've struggled to retrieve one of my favorite snacks from the chastity tube they reside in. Hours were spent contorting my digits into seemingly impossible configurations in hopes that I could snag just a few more chips from the stack. Gone are the days of pouring out chips, and thus crumbs, all over your lap so that the stragglers at the base of the well of gluttony can finally be consumed.

The solution to one of the worlds largest obstacles? The Pringle Sleeve.

A device that is inserted just after deflowering a fresh tube of pringles so that one does not encounter such difficulties as stated previously.

To Operate:
----------
Simply tilt the tube so that one side of the stack of chips is flush with the wall. Slide the thin portion of the sleeve down the opposing side where a gap has been created. When fully inserted, rotate the tube so that the chips are now resting on the sleeve's tab and not on the wall of the tube. Carefully flip the tube upside down so th
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
HIPS
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen