Thingiverse
The Rad Shad lure
von RenMauPer
57
Downloads
31
Likes
0
Makes
An inverted redesign of the Bullet Mullet. With the angled back mouth, it ought to function as a diving popper. Just mirror the BB version and glue the two halves together.
Print at 0.2 and 60-70% infill, then, depending on which one you printed, either pop in a few ball bearings and a wire and glue together, or simply slip the wire in. Finally, paint it, glue eyes on, yadda yadda yadda.
Post a make if you...you know...make one.
Print at 0.2 and 60-70% infill, then, depending on which one you printed, either pop in a few ball bearings and a wire and glue together, or simply slip the wire in. Finally, paint it, glue eyes on, yadda yadda yadda.
Post a make if you...you know...make one.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
