Thingiverse
The Vulp blade inserts
von N0obie
0
Downloads
5
Likes
1
Makes
I printed This on 0.2 layer height and 100% infill.
Filament used is transparent TPU (A82).
As added weight I used 3, 5mm magnetic balls (fidget toy). Overall it adds 3.30g.
It fits quite tightly so it wont fall of. But adding the balls is a bit complicated but if you get it right it stays quite tightly and it doesn't interfere with flipping.
Filament used is transparent TPU (A82).
As added weight I used 3, 5mm magnetic balls (fidget toy). Overall it adds 3.30g.
It fits quite tightly so it wont fall of. But adding the balls is a bit complicated but if you get it right it stays quite tightly and it doesn't interfere with flipping.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
