The Windicator V1

Behold The Windicator! Fun little weathervane/anemometer optimised for A1 mini on a single plate with a 4 hour-ish print Everything is push fit, you'll just need two 608zz bearings. I've printed in PLA and PETG. The tolerances are very tight so while it all fits together easily, with PETG I had to sand the cup arms very slightly. I'm favouring PETG because I don't want it to sag in the summer. I used ELEGOO rapid PETG with the Bambu labs PETG basic profile with the nozzle temps at 255 because I get horrible layer adhesion otherwise. The shaft is designed to fit some copper pipe I had lying around so I'll let you figure out how to mount it yourself. The shaft itself is the exact height needed to prevent binding in the top section. The thin part of the shaft is 16mm tall and 8.25mm diameter for a snug fit into the bearing. The shoulder tapers out to 13.6 diameter but as long as there's a taper to prevent the shaft touching the moving part of the bearing, this can