The Windicator V2 'Compact'

Here is V2 of my original V1 Windicator model. V2 is much more compact and chonky, 22.5cm nose to tail compared to V1 which is 31cm nose to tail. Being smaller, I've made a few significant changes from V1 I've done away with the counterweight Prints in fewer pieces (optimised for A1 mini) Included two mounting options Included a North indicator Everything is push fit, you'll just need two 608zz bearings. PLEASE NOTE: Please ensure that the supports are properly removed from the top hub. There's a raised ridge inside that the bearing sits on that creates a gap between the bearing and the hub roof so it's free to spin. Everytime I've printed the support has been left cleanly behind on the plate no worries, but do make sure that bearing is free to spin. Performance wise, near identical to V1… may need an infitesimal amount more wind to get it turning but they both spin in a light breeze. I've printed in PLA and PETG. I'm favouring PETG because I don't want it to sag in the summer. I used