Thin Rip Jig for Tablesaw

Table saws are dangerous. Print and use at your own risk. Designed to require very little additional hardware. The tolerances between sliding interfaces is about 0.2 mm. You may have issues with binding if your printer is not dialed in, so take it as a challenge!Hardware:M5 x 20 mm countersunk screw (x1) & nut (x1)M3 x 10 mm countersunk screws (x2)608-2RS bearing (standard skateboard bearing). If you do not have a bearing you can print the plastic bushing which will serve the same purpose but not be as good.Read Before Printing:Measure the gap from your table saw's mitre slot to blade tooth kerf (inside edge to inside edge). If the gap is less than about 5" (125mm), use the regular Slider.stl file. If the gap is more than 5" (125mm), use the Slider_Longboy.stl file.Measure