Thin Single Hand Sword

This is a sword that I modelled on OnShape. This is actually the upgraded version of the paracord dagger I made (I posted that as well), so I made the dagger and then decided to turn it into a short sword. The sword is about 67 cm in length (end of handle to tip of blade). Don't expect it to be super durable. I made the plates in the order of how you should put it together. You get the handle first, and then get the first blade segment and put superglue and hammer the flatter pin in. You do the same for the remaining segments. Then you align the handle part with the holes on the handle segment and hammer the taller pin into those to keep it in place. (If that makes sense).I recommend using a higher infill, since it might snap when playing around with it due to it bending a little. Just don't be too rough with it and you should be fine.