Thingiverse
ThinkNode M1/M5 webbing mount
von cracked_atom
0
Downloads
0
Likes
0
Makes
This is a quick release mount to attach a Elecrow ThinkNode M1/M5 to 25mm webbing.
**Build notes**
You will need two M2*4mm hex bolts to attach the back plate to the device.
PETG is preferable to allow for a bit of flex on the release tab.
Sanding may be required if the fit is too tight.
**Build notes**
You will need two M2*4mm hex bolts to attach the back plate to the device.
PETG is preferable to allow for a bit of flex on the release tab.
Sanding may be required if the fit is too tight.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
