Thingiverse
Third-Hand-Stand
door DoPeMW
19
Downloads
22
Likes
0
Makes
A third-hand-stand i created, can take up to 5 Arms.
Because of the missing threading the holes are minimal smaller.
Just heat both parts minimal and screw it in, fits realy good, but if you want you can glue it.
Big plus:
The part is 150*150mm, to prevent warping the base is seperated into 9 parts, there are small 2mm wide and 1mm high gaps so you dont need any support.
Created with TinkerCAD
Because of the missing threading the holes are minimal smaller.
Just heat both parts minimal and screw it in, fits realy good, but if you want you can glue it.
Big plus:
The part is 150*150mm, to prevent warping the base is seperated into 9 parts, there are small 2mm wide and 1mm high gaps so you dont need any support.
Created with TinkerCAD
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
