Thingiverse
Thread Bobbin
door sej7278
84
Downloads
80
Likes
1
Makes
Made the slits a bit thinner as the thread was coming loose on the original design.
Made the hole smaller and moved it a bit as it was too close to the edge.
v3 moved the hole a bit and made the design 0.5mm thick - and parameterised the thickness, so that it will fit one of [these](https://www.amazon.co.uk/dp/B003TL6CHM) winders
Made the hole smaller and moved it a bit as it was too close to the edge.
v3 moved the hole a bit and made the design 0.5mm thick - and parameterised the thickness, so that it will fit one of [these](https://www.amazon.co.uk/dp/B003TL6CHM) winders
sej7278 publiceert ook op
27 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
