Thingiverse
Threaded Dust Filter
por Kezat
2.2k
Descargas
1.3k
Likes
79
Makes
Best of both worlds, no plastic tabs that become loose over time yet the convenience of inline attachment.
No extra hardware other then the sponge needed. Should work for 1.75 and 3mm filament.
Pinch filament between each half of a cut sponge and push all three in the small side and screw on the end cap.
Kitchen sponges seem to dry out, I have found that "Cellulose Facial Sponges" work well and are easy to find.
3-17-15
Uploaded a thicker walled center component.
4-10-15
Uploaded a version of outer portion that can thread on to the bottom filament guide of a Craftbot 3d printer.
Check out my other designs: http://www.thingiverse.com/Kezat/designs
No extra hardware other then the sponge needed. Should work for 1.75 and 3mm filament.
Pinch filament between each half of a cut sponge and push all three in the small side and screw on the end cap.
Kitchen sponges seem to dry out, I have found that "Cellulose Facial Sponges" work well and are easy to find.
3-17-15
Uploaded a thicker walled center component.
4-10-15
Uploaded a version of outer portion that can thread on to the bottom filament guide of a Craftbot 3d printer.
Check out my other designs: http://www.thingiverse.com/Kezat/designs
Kezat también publica en
15 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
