Thingiverse
Threaded Rod Cap
door andrerc
0
Downloads
1
Likes
0
Makes
This is a cap for the threaded rods that most printers use for their z axis. I printed mine at 0.2mm layer hight but 0.1 would be better. They work well and just screw on to the threaded rods.
If you print this be sure to leave a comment or a make on what was good and what I can improve.
If you print this be sure to leave a comment or a make on what was good and what I can improve.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!