Thingiverse
Threadtest M8
von Fastmek
9
Downloads
8
Likes
0
Makes
With this test you can check which setting you will have to succeed with your threads. The design is made in Fusion 360 and it is printed with Flashforge Finder.
1 standard thread
1 thread -0.1mm
1 thread -0.2mm
Test this and you'll see which thread goes well right from the printer
Note that these are small details so prints with high accuracy.
The same test with larger threads will be uploaded tomorrow
On my printer -0,1mm works best.
Estimated time to print 18min
1 standard thread
1 thread -0.1mm
1 thread -0.2mm
Test this and you'll see which thread goes well right from the printer
Note that these are small details so prints with high accuracy.
The same test with larger threads will be uploaded tomorrow
On my printer -0,1mm works best.
Estimated time to print 18min
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!