Thrustmaster hall sensor lower

This is a remix of the original hall sensor mount that was posted by Thortazo. Thanks a lot for the great design.

I printed it and I noticed that the sensor was to far away. My t300 did not calibrate well. The sensor had to be perfectly placed so I lowered the two top rods where you mount the sensor with 2.5m and its now almost identical to the height of the original one.

I have attached the stl and a Fusion 360 file for if you want to adjust it. Its possible that it needs to be even lower.

Note: I used tree supports for the overhang on the underside of the model. It is not necessary but I would recommend it just in case. Especially if you don't have reliable fans. It certainly gave me a better print on the bottom and probably only adds a couple minutes.