Thrustmaster TWCS Throttle Knob

For me the knob for the Antenna axis (slider 0-axis) was a bit to large and prone to touching while operating the throttle axis.
Therefore I designed this slightly smaller knob which is more inline with the body of the Throttle. Not sticking out above it.
I use the TWCS for flight simulation and have the elevator trim axis setup on the "slider 0-axis" and accidentally changed the trim every time I changed the Throttle setting.

Not with this mod.

Note; The TWCS needs to be completely disassembled to change this knob as the screw is on the inside. Try to keep the gears inside meshed, otherwise you will change the "timing".
If that happens, no panic, there is a tiny mark on both gears which need to match each other. Check with the calibration tool before final assembly.