Thingiverse
Tiger Tooth
von DioKafaloh
45
Downloads
34
Likes
0
Makes
It is a typical keychain model of a Big and classic saber toothed tiger's tooth.
I recommend to print it at 10 microns,100% infill density, 30 mm/s. Supports don't really matter, once you're done you have to sand it with gradually thinner sand paper (try to get the highest quality as possible), I highly recommend to put some turns of copper on the bottom of the buttonhole.
I recommend to print it at 10 microns,100% infill density, 30 mm/s. Supports don't really matter, once you're done you have to sand it with gradually thinner sand paper (try to get the highest quality as possible), I highly recommend to put some turns of copper on the bottom of the buttonhole.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!