Thingiverse
Tile Bookmark
von Lettucewitch
3
Downloads
2
Likes
0
Makes
Just a little bookmark, or stencil.
I printed it in PLA. For best results printing complex patterns with holey sections, some settings that I adjust include:
1. Initial layer height, increase
2. Initial layer line width, increase to 125-150%, if object allows
3. Initial layer flow (increase) (Set to 125%)
I printed it in PLA. For best results printing complex patterns with holey sections, some settings that I adjust include:
1. Initial layer height, increase
2. Initial layer line width, increase to 125-150%, if object allows
3. Initial layer flow (increase) (Set to 125%)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!