Thingiverse
Tilt Case
door natko
4
Downloads
2
Likes
0
Makes
Case for tilt printer, designed for gen 3 electronis though 1/16 stepping will make nice hum noise rather than load noise i got.
Sorry its a router job, 4mm thick x 1200mm x 600mm sheet needed and designed for ITX PSU
And this will change when got build platform sorted.
Sorry its a router job, 4mm thick x 1200mm x 600mm sheet needed and designed for ITX PSU
And this will change when got build platform sorted.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
