Thingiverse
Tilted mouse pad
door SubSite
23
Downloads
29
Likes
0
Makes
A tilted platform to keep underneath your mouse pad. I find this much more comfortable for my wrist, and a cheaper option than buying an asymmetrical gaming mouse.
Fits a mouse pads sized 20 x 25 cm, you can always cut an old mouse pad down if it's too big.
At least my mouse tracks pretty good even on the bare printed surface (with 0.20 mm layers), but I would recommend printing at 0.1 mm layers if you plan to try this. The hard surface isn't as comfortable as a proper mouse pad, though.
Dove tail joint allows for printing on a Pusa bed (21 x 25 cm). The tolerance of the joint is 0.15 mm.
Fits a mouse pads sized 20 x 25 cm, you can always cut an old mouse pad down if it's too big.
At least my mouse tracks pretty good even on the bare printed surface (with 0.20 mm layers), but I would recommend printing at 0.1 mm layers if you plan to try this. The hard surface isn't as comfortable as a proper mouse pad, though.
Dove tail joint allows for printing on a Pusa bed (21 x 25 cm). The tolerance of the joint is 0.15 mm.
SubSite publiceert ook op
45 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
