Thingiverse
Time lapse Camera
von truglodite
5
Downloads
3
Likes
0
Makes
This is my enclosure design for the Arducam ESP32s UNO PSRAM board, a power switch, and 900mah lipo. I use this board to do timelapse videos. It gets over 24hrs battery life snapping 1600x1200 jpgs every 5sec, and the whole assembly costs just north of $30. The pcb has a built in lipo charger which is nice for this application. The 4mb psram allows the board to do AI stuff like face recognition etc, but that is not used in this case.
***Printing:***
Use supports on the bottom if you are picky about your counterbores, but it is not necessary for a functioning and good looking enclosure. Otherwise, it's an easy print and your usual settings should work. Note that the circuit stays cool, but PLA could warp if this thing is left in direct sunlight for long periods of time.
***Hardware:***
*Arducam ESP32s UNO PSRAM:*
https://www.amazon.com/gp/product/B07W8SMFTK/ref=ask_ql_qh_dp_hza
*1s900mAh lipo (preferably with battery protection circuit):*
https://www.amazon.com/AKZYTUE-Bat
***Printing:***
Use supports on the bottom if you are picky about your counterbores, but it is not necessary for a functioning and good looking enclosure. Otherwise, it's an easy print and your usual settings should work. Note that the circuit stays cool, but PLA could warp if this thing is left in direct sunlight for long periods of time.
***Hardware:***
*Arducam ESP32s UNO PSRAM:*
https://www.amazon.com/gp/product/B07W8SMFTK/ref=ask_ql_qh_dp_hza
*1s900mAh lipo (preferably with battery protection circuit):*
https://www.amazon.com/AKZYTUE-Bat
truglodite veröffentlicht auch auf
118 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
