Tinkerbell

This was an experiment to see if I could create a print of Tinkerbell with multiple shades of green but only 1 green filament. I think it worked out. Project: Tinkerbell ChibiPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x200mm in sizeYou may print at higher layer heights below the Min Depth of 0.64mmThe Max Depth is 2.5mm and the Actual Depth is 2.2mm This print uses 4 unique filamentsPLA BambuLab Basic Black PLA BambuLab Basic Green PLA BambuLab Matte Ivory WhitePLA BambuLab Basic Yellow Swap Instructions:Start with BlackAt 0.88mm swap to GreenAt 1.2mm swap to Ivory WhiteAt 1.28mm swap to YellowAt 1.76mm swap to Ivory White for the rest.