Thingiverse
Tiny Whoop E011 case base
door Undack
14
Downloads
13
Likes
0
Makes
A remix of the Tiny Whoop case base by GRay_111111 to fit E011 batteries in the slots on the perimeter of the case
original:
https://www.thingiverse.com/thing:2125627
This is only the base, it is compatible with the lid and tray from the original which are available from the link above. The tray is a little bit tight and only fits in one orientation but it does fit
A heated bed isn't required to print but without it be sure to disable all cooling and use a wide brim, i used 8mm
original:
https://www.thingiverse.com/thing:2125627
This is only the base, it is compatible with the lid and tray from the original which are available from the link above. The tray is a little bit tight and only fits in one orientation but it does fit
A heated bed isn't required to print but without it be sure to disable all cooling and use a wide brim, i used 8mm
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!