Thingiverse
Tiny Whoop Propeller Remover
von darren_bergen
48
Downloads
42
Likes
0
Makes
A propeller removal tool for Tiny Whoop/Inductrix.
Two sizes with 6mm and 7mm width.
Tool seem best by placing under the duct and pulling in the direction of the motor.
Not sure how well this works. Tighter props seem to be a problem.
STL is in print ready orientation.
Two sizes with 6mm and 7mm width.
Tool seem best by placing under the duct and pulling in the direction of the motor.
Not sure how well this works. Tighter props seem to be a problem.
STL is in print ready orientation.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
