Tiny Y-Splitter FULLY 3Dprinted

Update : I forgot to mention that you should not try to screw the threads if you haven't inserted the ptfe tube inside the splitter, the lips on which you screw the threads can eventually break. I will make it thicker when I have time to get back on the drawing. Tiny Y-Splitter for PTFE tubes that you can use on any 3D printer, and it is fully 3D printed. It is compact and light enough (less than 3 cm in height and weighing only 1.5 g) to be used anywhere on a printer, and it won’t bother your toolhead at all if you place it directly above your extruder. Just keep in mind that you have to tighten the bolts a little bit—but not too much—and by hand only (please don’t use pliers). No PC4-M5 needed. To prevent it from breaking, you must use PETG, as it needs a bit of elasticity at the threaded parts. Printed at 0.16 mm layer height. You can go lower, but higher layer heights tend to result in a loose bond between layers, and the threads will break after four or five cycles of screwing