Thingiverse
Tinyhawk2 Freestyle Camera Fin
von IgorFPV
6
Downloads
5
Likes
0
Makes
This is the camera fin replacement for Tinyhawk2 Freestyle.
The original is made with carbon fiber and works well, but it makes i hard to fit slighly bigger cameras like Foxeer Toothless 2 nano: It can't be tilted up enough.
This fin moves the camera holes out a bit to allow full tilt motion.
It also has 2 notches on the front. one for 25 degrees one for 20 for ease of setup.
The original is made with carbon fiber and works well, but it makes i hard to fit slighly bigger cameras like Foxeer Toothless 2 nano: It can't be tilted up enough.
This fin moves the camera holes out a bit to allow full tilt motion.
It also has 2 notches on the front. one for 25 degrees one for 20 for ease of setup.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
