Tissue Box

A Tissue dispenser/box. Made to hold the costco tissues, but I've also fit a box of kleenex balsam tissues in as well. Either use the lid, or use the plate (the black one in the picture) or use them both. I started out with the plunger/plate in the hope it will ensure the next tissue always pop's up even when you get down to the last couple of tissues in the box (1st world problems!). This may or may not work, I'll find out when I get to the bottom of the box.I added the lip part as my partner didn't like the look of just a box without a proper lid. This also means you can add more tissues than will fit in the box and the lid will just slide down as the stack of tissues runs down. You're smart people, I'm sure you'll figure it out.Category: Containers This prints well in PETG and PLA, not tried anything else, but the one in the picture the base is PETG and the lid is PLA.