Thingiverse
TL Smoother case
von mlinuxguy
82
Downloads
55
Likes
2
Makes
This is a case for the TL Smoother diode board typically used to get smoother movement especially on a delta-style 3Dprinter using DVR8825 stepper drivers or A4988/2 drivers. It reduces the "salmon" effect where a pattern appears across the surface.
I used thermal paste to mount the heat-sink horizontally since the diodes can get hot.
This case is designed to use 2mm by 5mm long screws, however only one screw is needed since its such a tight fit when printed in ABS plastic.
The TL Smoother board I ordered was from Amazon, however the same model is available on ebay and other locations. The bottom of the board says: BIGTREETECH v1.0, it's dimensions are: 30mm by 40mm.
The search string to use on Amazon is: ARQQ TL Smoother Addon Module for Pattern Elimination Motor Clipping Filter 3D Printer Stepper Motor Drivers (Pack of 3pcs)
Update: I added a before and after TL-Smoother photo. See if you can guess which is which.
I used thermal paste to mount the heat-sink horizontally since the diodes can get hot.
This case is designed to use 2mm by 5mm long screws, however only one screw is needed since its such a tight fit when printed in ABS plastic.
The TL Smoother board I ordered was from Amazon, however the same model is available on ebay and other locations. The bottom of the board says: BIGTREETECH v1.0, it's dimensions are: 30mm by 40mm.
The search string to use on Amazon is: ARQQ TL Smoother Addon Module for Pattern Elimination Motor Clipping Filter 3D Printer Stepper Motor Drivers (Pack of 3pcs)
Update: I added a before and after TL-Smoother photo. See if you can guess which is which.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
